Skip to content

TrailView ground plan: a shoulder that two lines of one road reach jumps in height at a fold #3530

Open

Description

@timohueser

Part of #3096. Found by the review of #3529.

Fault

With the sidewalk bits of #3529, the fixture has one more height step inside a face: 3.1 m in a road shoulder at 46.82069, 8.39291. The place is a dead-end road with a short hook way that climbs 3 m. heights_fixture counts 10 steps inside faces; the gate INSIDE_MAX was 9.

Cause

A shoulder face has no host line of its own. host() in host/obc-ground-plan/src/faces/heights/mod.rs takes the nearest line for each point. At the fold, two lines of the same road (about 1015.8 m and 1018.9 m) both reach one shoulder face. The height jumps where the nearest line changes. The new bits give the fold an inner round, and that round leaves a small shoulder patch that both lines reach.

The fault is in the ground plan. The bits only show it.

Fix

Give each band face its own host line (band ownership, already planned with the sidewalk step that stops paths at the slab). Then measure the gates again and set INSIDE_MAX back to 9 or lower.

State

#3529 sets INSIDE_MAX to 10 and names this cause beside the gate. From above, the place shows a seam and a dark crescent under ground=plan. The default path does not show it.

Requirements: none


Generated by Claude Code

Metadata

Metadata

Assignees

No one assigned

    Labels

    No labels
    No labels

    Projects

    No projects

      Milestone

      No milestone

      Relationships

      None yet

      Development

      No branches or pull requests

      Issue actions