Clock out before burnout!
A Flipper Zero app that turns the device into a work-shift and overtime timer for remote workers. Built for Flipper Zero to reduce distraction and not to draw attention to your phone.
12-hour analog dial showing actual time of day, tracking elapsed work time, breaks, and a prediction of how much of your shift is left. Hourly chimes, vibro, always-on backlight (everything is optional), highly optimized as a full-time running app.
Setting up a shift (before you start):
- Left / Right - adjust the configured shift length (1-12 hours)
- Up / Down - switch the time format between
H:MMandH:MM:SS - OK (tap) - start the shift
- OK (hold) - open the info and options
- Back (hold) - close the app
While working or on a break:
- OK (tap) - pause / resume
- OK (hold) - reset back to the shift-setup screen
- Up - toggle mute
- Down - toggle backlight
- Left - toggle vibration
- Right - toggle eco mode
- Back (hold) - close the app
Info and options screen:
- Left / Right - cycle between pages
- Back - return to the shift-setup screen
As an app made to run at least a third of the day, it is highly optimized, buffering every heavy calculation needed for rendering. Rendering runs at one screen refresh per second when animation is active, or two refreshes per minute in eco mode.
My personal tests show it runs on my Flipper Zero with very little overhead. Here are some battery drain stats for a 9-hour time period:
- Nothing is running: -2% (for reference)
- In eco mode without backlight: -3%
- In normal mode without backlight: -4%
- With backlight active: -11%
So, basically, the app itself adds about 1–2% drain for a full working day.
This is a Flipper Zero external app (FAP), built with ufbt:
pip install ufbt
ufbtTo build and immediately launch it on a connected Flipper:
ufbt launchOr simply connect the Flipper Zero to your machine and run launch_app.sh.
The source code is licensed under the Apache License 2.0. The "Clock'o'Dial" name and icon are trademarks and are not covered by that license - see TRADEMARKS.md before publishing a fork under the same name.
This repo follows the Conventional Commits specification.



