Microprobe Blocks in deployed status

[saamrh]

I am using BIQU microprobe, but when switching on the printer it tests three times properly and ends deployed. After that if never stows, even if you power off with the probe deployed and power on again, you can se how it tries to stow with no success. But, if yoou stow manually the probe and restart again, it does the same , tests properly three times ends in deployed status and back to the same behaviour, blocked deployed.... I am bulding a mercury one , with an octopus v1.2, orbitool O2 and klipper.

Thanks

[saamrh]

Update. Connected to the motherboard everything fine. Responds to commands and endstop query properly. But one last thing, when homing bed does not stop when touching the probe. If i slightly press the probe with my finger before bed arrives , it does. Probe deployed is about 2mm below nozzle , should I allow more distance to leave bed add more pressure?